CK5 - The Full-Size GM Off Road Community

I am getting bored with my truck and want to go a different route. Here are her specs.

1978 K5 Blazer
350sb chebby with an edlebrock carb, new plugs and wires, the engine is good but I've been having some fuel problems (probably just a vacuum leak or fuel pump), She idles fine but has some choke out issues when driving. Probably a quick fix.

TH350 tranny, no problems since I've had it.

Np203 trans. again no problems

Rear end: is a 14 bolt full floater 3.73 open.

Front end: is my old 6 lug 10bolt. It has a mini spool in it and 3.08 gears (i have the 3.73 gears ready to install) new milemarker lockouts.

Lift: 6 inch superlift

Tires: 38.5x14.5 TSL SX (20%) and a set of used 35x14 GHawgs if you want.

4 point smittybuilt cage

this truck has a lot of sawzall work. The top has been chopped off and so have the fenders. The doors and the tailgate are not on the truck but I have them if you want. I have run this truck for about a year and want to play with something else. I'm open to trades just ask.
I'm asking $2,300 but reasonable offers will be accepted. Located in Auburn, AL. Call David @ 334-319-2985 or email @ lukerdl@auburn.edu (lukerdl@auburn.edu)

See pics here http://www.pavementsucks.com/gallery/viewride.php?ride_id=2894 (http://www.pavementsucks.com/gallery/viewride.php?ride_id=2894)

ttt

TTT and a price drop $2,000obo

how much rust? got a title?

Got a title in GA, good bit of rust in the floor boards etc...but frame/susp. all the important stuff is fine. I've flexed it and beat it pretty good and everything has stayed tight...not exactly the kind of truck you worry about body rust though:D thanks for the interest

A little update also...I'm gathering the parts as we speak to complete the front axle. It will have the matching 3.73's and will be 8 lug w/in the next few weeks. I'm probably going to stay firm @ $2,000 since I'm spending the $$$ on these parts, but I'm still open to trades :D

ttt