K5 Blazer Forums  
Home of the 1969-91 K5 Blazer/Jimmy including GM Trucks and Suburbans.  
Go Back   CK5 Forums > General Discussion > The Garage

Remove these ads.

Reply
 
Thread Tools Display Modes
Old 03-24-2003, 08:22 PM   #1
dawson444
Supporting Member
Registered User
 
Join Date: Jul 2000
Location: Raleigh, NC
Posts: 1,034

i Trader: (0 )

Which way do rod bearing caps go on in a chevy 350???

Let me just state my question instead of getting into the details of what I'm confused about.
When I put the rod bearing caps on the bottom end of my 350, there is a little bearing tang or notch on both the bottom of the rod and the bearing cap. I put the bearings in. Then when I am bolting them together, do the tangs need to just be on the same side of the crank or do they need to be lined up right next to each other like crearing one big tang? I'm not sure how much sense this makes. Thanks for your help!
dawson444 is offline   Reply With Quote
Sponsored Links



Remove these ads.
Old 03-24-2003, 08:37 PM   #2
Don
Registered User
 
Join Date: May 2002
Location: Spokane Washington
Posts: 1,779

i Trader: (0 )

Re: Which way do rod bearing caps go on in a chevy 350???

Tang to Tang. Have You had the Rod's/Piston's out?
Don is offline   Reply With Quote
Old 03-25-2003, 09:09 PM   #3
Lonnie
Registered User
 
Join Date: Dec 2001
Location: Pittsburgh, PA
Posts: 138

i Trader: (0 )

Re: Which way do rod bearing caps go on in a chevy 350???

Yes, tang to tang.

Also the numbers on the rods should face the pan rail putting the edge of the rod with the biggest chamfer against the crank edge.

Arrows on pistons should always face forward.
Lonnie is offline   Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -7. The time now is 01:16 AM.


Powered by vBulletin® Version 3.8.1
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.